Now direct your attention to the hood hinge area. Open the hood all the way by pushing the hood stop (blue arrow) out of the way. Now using a straightened metal coat hanger or fish tape and guide the wiring harness to the front of the car. To do this simply take the end of the harness with the two white wires and tape it to the coat hanger/fish tape and slowly guide it to the front of the car. Once the two white wires are guided to the front of the car, remove them from the coat hanger. Now, using the coat hanger once again, fish the other end of the harness through the hole that the emblem left behind.

         With both ends of the harness in place, you can now concentrate on the wiring. Pull a few inches of wire out of the loom that connects to the front turn signal. There should be three wires. Which two wires you splice depends on when you wish the lights to turn on.

Wiring Color Scheme

	Driver Side	Passenger Side
Turn Signals	Green and Black	Blue Striped Green & Black
Side Markers and Signals	Green and White	Blue Striped Green & White

         To splice a wire simply open the wire splice all the way and slide it over the factory wire you wish to tap into. Now, close that half of the splice, and insert the white wire from the new harness. Using pliers clamp down on the metal part of the splice. Check to make sure the two wires are spliced. Fold over the blue cover to complete the splice. If your signals are connected they should now work. If not the most likely cause is that you did not clamp the splice hard enough or missed the wire when you did.

         The turn signal should snap easily into place now. Once this is done all that is left is to make sure the harness is tucked up out of the way. As soon as you repeat this procedure on the other side of the car you are done.

Congratulations!

 

Sponsored Links:

Volvospeed assumes no responsibility for any damage done to your car. All modifications are done at your own risk.
Copyright 1999-2007 Volvospeed. All rights reserved.