This is mainly directed twd Rich only because I don't remember it happening to anyone else....


141 Faulty pedal sensor, shorted to ground or supplly

142 Faulty brake pedal switch, open or short


Occasionally, when I brake hard to come to a sudden stop (no skidding, just stopping a bit hard), my ABS light will come on....Usually, I just turn the car off and back on again, and ABS light goes away. I decided to get the codes the last two times this happened....

Any fixes?

Thanks,
-Pras-

Hi Mate

I have had so crappy abs issues recently and while I was searching I found this, - it quotes abs fault - 141 and 142!!

http://au.geocities.com/ozbrick850/abs-141142.html

Hope it helps
Matt

bump

The above pic, shows the source of the ABS 141 code the brake pedal sensor. It's the one colored in blue.

The ABS 142 is the actual brake pedal (light) switch on the pedal inside the car, down under the drivers side kick panel. To get the brake pedal switch out is a trick without destroying it. Good idea to have the new one handy before starting. A bad brake pedal switch can also cause the "it wont come out of park" syndrone. To get the switch out easier, Push the brake pedal switch down, then shove the back of the switch, you will hear it ratchet, then the clips that hold it in place will release easier. When you put the new brake pedal switch in clip it in place, push it forward so it ratchets as far forward as it will go then slowly release the break pedal and it will set the switch.

ouch, do you have part numbers for each of these little guys? I'm assuming that pic of the pedal sensor is under the hood behind the fluid reservoir? Is it very important to fix? It has to do with the brakes, so I'm assuming I should get it done!

The blue thing is part number 271892.

Need your chassi number for the brake pedal switch, there are two to pick from.

chassis number? would a VIN number be the same thing?

Chassi is the last six of your vin.

got it, thanks...will be calling FCP tomorrow for pricing!