While I almost narrowed down to my ETM being bad, the check engine light came on yesterday
I scanned for codes and got
P0455
P0440
P0446
evap emission codes leaks..
After erasing these codes car behaves weird idles at 1500rpm sometimes and sometimes barely stalling the message reads :
Also car goes into limp mode, if I restart it its fine but goes to limp mode eventually
Are these codes effect the idle or my ETM is just shot?
Any ideas? Thanks for any input
0
Limp Mode, More Problems
Started by Dmsee, Jan 19 2012 01:45 AM
5 replies to this topic
#1
Dmsee
-
- Supporting Member
-
- 6,579 posts
Level 5 Member
- Location:Woodstock, GA
- Crew:___
#2
Dan A
-
- Lifetime Supporter
-
- 1,809 posts
Old Man Crew Pledge Pres.
- Gender:Male
- Location:Minneapolis, MN
- Crew:MWC
Posted 23 January 2012 - 02:10 PM
Most likely unrelated I should think.
99 V70R
98 V70 GLT
#3
Keaton85
-
- Members
-
- 6,439 posts
My zip tie is bigger than yours.
- Gender:Male
- Crew:___
Posted 23 January 2012 - 03:34 PM
Are you planning on doing the ETM soon?
#4
Dmsee
-
- Supporting Member
-
- 6,579 posts
Level 5 Member
- Location:Woodstock, GA
- Crew:___
Posted 23 January 2012 - 10:53 PM
Already done with Xemodex, so far so good
Looking for a tune now
Looking for a tune now
#5
Ihatespeedbumps
-
- OH Moderator
-
- 3,479 posts
The Pied Piper
- Gender:Not Telling
- Location:Nashville
- Crew:___
Posted 25 January 2012 - 04:34 AM
So you've installed the xemodex recently?
The evap codes will not cause a poor running condition, unless something unusual is happening like the evap valve is stuck open and your a topper upper, so the charcoal canister is filled with raw fuel and it's being sucked into the intake.
Edit: I'd start looking for an evap leak, likely at the J hose that comes out of the charcoal canister.
The evap codes will not cause a poor running condition, unless something unusual is happening like the evap valve is stuck open and your a topper upper, so the charcoal canister is filled with raw fuel and it's being sucked into the intake.
Edit: I'd start looking for an evap leak, likely at the J hose that comes out of the charcoal canister.
98 S70 T5M
#6
Dmsee
-
- Supporting Member
-
- 6,579 posts
Level 5 Member
- Location:Woodstock, GA
- Crew:___
1 user(s) are reading this topic
0 members, 1 guests, 0 anonymous users
