9 replies to this topic

[T5Hammy]

So recently the ziptie holding my wideband connector (6-pin connector from bosch 4.2 sensor to the wire harness) broke, leaving the connector to drag on the ground and get destroyed.

My question is does anyone know where to buy one of the connectors only, or if not can I hard wire the sensor to the harness (not sure if its just a 6-pin connector or if there is any kind of required circutry in it). AEM doesn't appear to provide them, here is the gauge/sensor setup I'm running: http://www.aemelectr...-fuel-gauge-25/

Any help is appreciated, Thanks

[s_moneh]

i'm on the same boat, due to testing and what not i took need that same wiire, i've been looking aswell to no avail so i'll be sub'd here

[gmsgltr]

ebay? there are always parts of the aem uego on there

[mojojo]

It doesn't look like there's any more to it. Can you disassemble the connector?

Can either of you post a close, detailed, clear picture of the connector you need?

If yes, get me these angles:
1-side shot
2-center shot, showing male and female pins

If you can get me these pictures, I may be able to get you a replacement connector. Worst case scenario, remove the connector and use a deustch connector. I could get both of you these connectors (1 male, 1 female).

[mojojo]

Did some quick searching here, definitely looks like there's more to it than a typical connector. There appears to be some tabs that you should be able to release and start to disassemble the connector. When you can take it apart, let us know what you find.

[s_moneh]

gmsgltr, he is right

this one seems to be what i personally need..

as for op not too sure

http://www.ebay.com/...967324552597584

[T5Hammy]

mojojo, on 02 February 2012 - 04:42 AM, said:

Did some quick searching here, definitely looks like there's more to it than a typical connector. There appears to be some tabs that you should be able to release and start to disassemble the connector. When you can take it apart, let us know what you find.

I will pull it apart and see whats inside for future reference.

s_moneh, on 02 February 2012 - 06:14 AM, said:

gmsgltr, he is right

this one seems to be what i personally need..

as for op not too sure

http://www.ebay.com/...967324552597584

Yup that looks like it, didn't know the uego had the same connector. I'll need that and the sensor though if I take my old one apart and it looks too complex for me to jury-rig.

Thanks guys!

[s_moneh]

they sell the o2 sensor seperatly on ebay aswell

[mojojo]

T5Hammy, on 02 February 2012 - 08:04 AM, said:

I will pull it apart and see whats inside for future reference.


Yup that looks like it, didn't know the uego had the same connector. I'll need that and the sensor though if I take my old one apart and it looks too complex for me to jury-rig.

Thanks guys!

Take pictures, and post here. I may be able to find you a perfectly fine/functioning/safe work around for spending more money... but it is your call.

[T5Hammy]

mojojo, on 04 February 2012 - 04:47 AM, said:

Take pictures, and post here. I may be able to find you a perfectly fine/functioning/safe work around for spending more money... but it is your call.

Definitely, I should get a chance to get some pics this weekend

Thanks