Dan A

I'm pulling an angled exhaust housing from a car that is getting parted. Got the vband clamp off and 3 of the 4 nuts to the engine, but I can't seem to reach that lower nut towards the driver's side? What's the trick or favorite tool here? I was trying a flexible ratcheting box wrench.

Worked on it for about 1/2 hour and decided to just give it a rest and attack it another day. I just don't seem to have any room back there to get a wrench on it and room to move. It's on a 99 AWD so technically wrong forum, but shouldn't be much different than any other. Mods can move if needed.

My car pc has been on the fritz for a while. I had my whole dash out last weekend, so I decided to just pull it out for now until I have some time to look in to it and reinstall my stock SC900. When installing my pc, I didn't do anything with the stock harnesses, I just used adapters to hook in to the stock amp.

My problem is that it's been a while since I've had the stock radio in there and after hooking everything up the way I thought it was supposed to go, I get power to the radio but no sound.

There are two wiring harnesses with the exact same connector that fit the back of the radio. I tried one which didn't power the radio at all, then tried the other. The other powered it on and I entered the code. I see stations and it shows that it is tuning with the station/song info, but no sound.

I have three questions.

1) What is this second connector for (see picture)? Is it supposed to connected somewhere? I do not have Dolby nor the 6cd changer.

2) There is a small green connection in the back of the head unit that doesn't have any label. I didn't see anything that plugs in to it and I fished around the wiring a few times. Am I missing something there? I seem to recall that this might be for the center channel or Dolby but I'm not sure.

3) There are two individual wires (pink/black) with single connectors, also pictured towards the right side. I have no idea what they plug in to. Any idea there?

Please help! Many thanks.