lextildeath
-
Posts
421 -
Joined
-
Last visited
Content Type
Profiles
Forums
Gallery
Blogs
Downloads
Events
Store
Bug Tracker
Everything posted by lextildeath
-
Friggin' wow dude! Did you ever get any updated numbers with higher boost?
-
Ya mon. I started working on the orange siht box again mon. I still have those rods for you if you need them. Maybe I'll bring my 2.0T to one of these meets if the C70 is still garbage - it's nice.
Laterrr
-
7tu7uiyu
-
-
From the album: fhjkf
© Volvospeed © 1998-2008
-
Sounds literally like jumping jacks and you get an extreme loss of power. Any way I have 5 fresh OEM rods from my new motor unharmed I can just give them to you if you wanna save money and go OEM.
-
turning a LPT into HPT
-
-
-
-
From the album: Engine Build
So you can distinguish the numbers on them from the turbo cams.© Volvospeed © 1998-2007
-
From the album: Engine Build
So you can distinguish the numbers on them from the turbo cams.© Volvospeed © 1998-2007
-
From the album: Engine Build
So you can distinguish the numbers on them from the NA cams.© Volvospeed © 1998-2007
-
From the album: Engine Build
So you can distinguish the numbers on them from the NA cams.© Volvospeed © 1998-2007
-
-
From the album: Engine Build
Not completely cleaned yet but mostly nice nice.© Volvospeed © 1998-2007
-
From the album: Engine Build
© Volvospeed © 1998-2007
-
From the album: Engine Build
All shiny and ready for the NA cams that are about to go in there.© Volvospeed © 1998-2007
-
From the album: Engine Build
Crank is getting balanced and is not in this or any pictures yet.© Volvospeed © 1998-2007
-
From the album: Engine Build
© Volvospeed © 1998-2007
-
From the album: Engine Build
After being machined- Over 3mm thick measured with caliper on bottom of block. Next pic shows top side of block where sleeves are slightly thinner.© Volvospeed © 1998-2007
-
From the album: Engine Build
After being machined- Almost 3mm thick measured with caliper on top side of block. Previous pic shows underside of block where sleeves are stepped and are even thicker.© Volvospeed © 1998-2007
-
From the album: Engine Build
Yes it is a Mahle piston with a 9.0:1 compression ratio.© Volvospeed © 1998-2007
-
From the album: Engine Build
© Volvospeed © 1998-2007
