turbodog

Where'd you get the steering wheel?(love it) is it factory and if so does it come from the 850 or from the s/v/c70 series? thanks

Same here, but it was all good on the inside. Thanks again for doing this. I think it will clean up the cracked dash quit nice.

it says right on the email flyer that its 70 hp and 80 ftlbs... (If I Recall Correctly)

fix the gap on the drivers side. and these pics make it look much better.

ok, this should be obvious but when you get .4 OD piston you bore your cylinder walls the same .4? would you recommend decking the block at all? or anything else to the block for that matter?

thanks for the reply. also, i must have missed it in your build up about the 960 butterfly in the n/a body. good to know.

just to beat a dead horse and for arguments sake could one just buy a n/a intake and throttle body and install it on a turbo'd car? and of course removing the big plastic piece on the n/a TB butterfly. is there any reason why this wouldn't just bolt straight up. this way you wouldn't have to modify the turbo intake manifold...

just bought 6/26. '95 855 T-5R baby. of course it needs a lot of work...