Ok had the p0410 fault and soldered in the proper diode in the em, on the right pins. Drove the system readiness procedure twice. No p0410 so thats gone yea. Now i didn't disconnect anything, just removed the ecm, soldered the diode in place, and put it back together. Now after my readiness drives, I plugged into the OBDII connector and rescanned to see if the system was ready, and found there was a pending fault p0455, for a large emissions leak. This fault was not present before. I scrolled through all 25 pages of this post, and I've seen a few people come up with the p0455 fault after doing this mod. Did anyone ever figure out why this is happening? Is it just a coincidence after the mod? Actually the check engine light didn't come on yet, I just noticed the fault when I rescanned. I since cleared the p0455 fault. I'm going to put more fuel in the car, it was on ¼ tank. So maybe that has something to do with it. Any further insight?