MeanGreenSwedeMachine Posted September 19, 2008 Report Share Posted September 19, 2008 So I'm looking at a set of S40 wheels, but I'd have to get them bored to fit my S70. What could I expect to pay for that? I was also looking at the H&R spacer adapters. Would that be cheaper, and is there any downside to using those?Thanks Link to comment Share on other sites More sharing options...
dmelviØØ7 Posted September 19, 2008 Report Share Posted September 19, 2008 I think Carson paid $50 per wheel to have them machined to fit. It's kind of a toss up. I'd go the machining route because I can't run spacers :( Link to comment Share on other sites More sharing options...
BtownVolvo Posted September 19, 2008 Report Share Posted September 19, 2008 I think Carson paid $50 per wheel to have them machined to fit. It's kind of a toss up. I'd go the machining route because I can't run spacers That's what I paid as well. Matt got spacers. I'd prefer machined but that's just me. You can kind of see the difference here:I lost some turning radius i rub so bad, his barely rubs. However, he had to roll his fenders and it rubs there. Link to comment Share on other sites More sharing options...
dmelviØØ7 Posted September 19, 2008 Report Share Posted September 19, 2008 That's what I paid as well. Matt got spacers. I'd prefer machined but that's just me. You can kind of see the difference here:I lost some turning radius i rub so bad, his barely rubs. However, he had to roll his fenders and it rubs there.Nice monster truck :P Link to comment Share on other sites More sharing options...
MeanGreenSwedeMachine Posted September 19, 2008 Author Report Share Posted September 19, 2008 Thanks guys. If I do get them I'll probably just get them machined since it'll end up being cheaper.I can always grab some 5mm spacers if they rub too bad. Link to comment Share on other sites More sharing options...
BtownVolvo Posted September 19, 2008 Report Share Posted September 19, 2008 Nice monster truck That's matts car in the foreground :rolleyes: Link to comment Share on other sites More sharing options...
prasamin Posted September 19, 2008 Report Share Posted September 19, 2008 get them machined....you can always run spacers as an option, rather than using the spacer adapters and not having a choice as to the width. Link to comment Share on other sites More sharing options...
PhilippineT5 Posted September 19, 2008 Report Share Posted September 19, 2008 ya, carlo and dookie are now VS members after all, it'll be both there cars that will be shown at the 2008 Manila Auto Salon Show ersh, i think you should help carlo be computer literate i even did both there sigs & avatars..id suggest you get them machined. Link to comment Share on other sites More sharing options...
dmelviØØ7 Posted September 19, 2008 Report Share Posted September 19, 2008 That's matts car in the foreground Neither of which are low enough. Link to comment Share on other sites More sharing options...
PhilippineT5 Posted September 19, 2008 Report Share Posted September 19, 2008 Neither of which are low enough. ouch :o Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.