TainterRacing Posted August 1, 2016 Report Share Posted August 1, 2016 I have a new etm, new plugs, coils and injectors as well. It was running fine for like 1-2mins then it would just run very ruff in limp mode. I can get the car started now but its only running on 2 cly. then just now to a point where it will not run good at all no matter what I have done any one have any ideas?? Now I have P1618 and P0605 codes I know it has to do with the ecu any one have any ideas other then a new ecu? 1999 glt v70 Link to comment Share on other sites More sharing options...
Matty Moo Posted August 3, 2016 Report Share Posted August 3, 2016 No firsthand experience with the 0605 but it's a ROM error in the TCU and you don't want that code. Link to comment Share on other sites More sharing options...
Ihatespeedbumps Posted August 3, 2016 Report Share Posted August 3, 2016 Tell us more about this "new" ETM you've got installed. Link to comment Share on other sites More sharing options...
TainterRacing Posted August 8, 2016 Author Report Share Posted August 8, 2016 Ok got the car running good motor wise any how..... still have p0605 and a P1618 transmission is in limp mode. Up arrow blinking. I got a XeMODeX etm replacement for the last one when bad. I got one when they first came out years ago. any how they replaced it frr of charge. Link to comment Share on other sites More sharing options...
TainterRacing Posted August 11, 2016 Author Report Share Posted August 11, 2016 i get the up arrow blinking even before I start the car.......... Link to comment Share on other sites More sharing options...
Ihatespeedbumps Posted August 15, 2016 Report Share Posted August 15, 2016 Do you have access to VIDA? Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.