DHV70 Posted September 14, 2009 Report Share Posted September 14, 2009 So I was taking the flywheel off of a 98R engine, and two of the bolts stripped out. I tried to drill them / use a grab-it to extract them, but because of the torque on them, the drill won't even hold onto the bit. I've tried using three and they all just open up and spin in the end. I'm thinking about drilling the heads off so I can get the wheel off, but still have the same problem after that... Any suggestions? Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.